Bosch 10" CM10GD Axial Glide Miter Saw Dust Collection
Hose Adapters:None
Extras:None
Quantity:
Finally a solution that replaces the terrible dust collection attachment on your Bosch CM10GD Compound Sliding Miter Saw! You will see a HUGE improvement in dust collection efficiency with this upgrade - all without losing much saw capacity! In the rare cases where this dust chute gets in the way, simply remove it via (2) thumb screws and replace when you're done. This chute is printed in a green/blue (close to Bosch colors) high strength PETG plastic with red accent anodized thumb screws.
NOTE: This solution is designed SPECIFICALLY for the CM10GD model number. There is no guarantee that this will fit any other Bosch saw.
Due to the initial interest level this listing is for a PRE-ORDER of the dust collection chute assembly with a stated lead time of 3-4 weeks initially. Once we get through the initial order volume, the lead time will shrink. We appreciate your patience!
Included:
(1) Dust Collection Chute Body with a locking suction hose connection
(1) Hub Mount that attaches to the saw blade shroud
(1) Flexible rubber flap
(2) Red anodized knurled aluminum thumb screws for attaching the chute body to the hub mount
(4) Small phillips screws for attaching flap to the chute body
(1) Install Card with QR Code for complete installation video
There is an option to add a dust collection fitting to accommodate the common dust collection hose sizes. If you don't see one you need, just ask!
If you're in desperate need of some cleanliness in your shop, look no further! This product was meticulously designed and tested to optimize dust collection efficiency while balancing the constraint on the saw. Thank you!
NOTE: This solution is designed SPECIFICALLY for the CM10GD model number. There is no guarantee that this will fit any other Bosch saw.
Due to the initial interest level this listing is for a PRE-ORDER of the dust collection chute assembly with a stated lead time of 3-4 weeks initially. Once we get through the initial order volume, the lead time will shrink. We appreciate your patience!
Included:
(1) Dust Collection Chute Body with a locking suction hose connection
(1) Hub Mount that attaches to the saw blade shroud
(1) Flexible rubber flap
(2) Red anodized knurled aluminum thumb screws for attaching the chute body to the hub mount
(4) Small phillips screws for attaching flap to the chute body
(1) Install Card with QR Code for complete installation video
There is an option to add a dust collection fitting to accommodate the common dust collection hose sizes. If you don't see one you need, just ask!
If you're in desperate need of some cleanliness in your shop, look no further! This product was meticulously designed and tested to optimize dust collection efficiency while balancing the constraint on the saw. Thank you!
